Beckhoff CP22xx Manual do Utilizador descarregar pdf (Página 21)

Installation

3.4 Fitting the power supply cable

Fit the cables for the power supply of the Industrial PC, the connection of the battery pack as well as the

connection of the power-switch in accordance with the wiring diagram, using the included material for

assembling the connectors:

Material for assembling the connectors

Plug connector 8-pole, Strain relief housing with lacing cord

Conductive cross-section

Note

The connector is specified for 16 A and can lift conductive cross-sections until 1.5 mm

So the connector is fitted to the cable:

1. Strip insulation from the cable ends (Length of stripped conductor is 8 – 9 mm).

2. Screw together the cable ends in the 8-pole plug connector in accordance with wiring diagram.

Applying the strain relief

Thread the lacing cord into that lower part of the strain relief

housing.

Putting in the plug connector

Put the plug connector into that lower part of the strain relief

housing.

Tighten the lacing cord and pinch off the plastic strap.

Fixing the upper part of the strain relief housing

Fix the upper part of the strain relief housing by snapping it onto

the lower part.

CP22xx 19

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Sem comentários

Beckhoff CP22xx Manual do Utilizador Página 21