Beckhoff M1410 Manual do Utilizador descarregar pdf (Página 8)

M1410 Parallel Input / Output Beckhoff II/O-System

Page 8 von 14 Version : 2.0 Date : 2.8.94

It depends on the state of the switch whether a port is output or input :

’ON’ => port is output

’OFF’ => port is input

ATTENTION:

Configuring a port as input ( switch "OFF") all of the eight output controller

ICs of the port concerned have to be removed.

If the ICs are not removed the port is not functional as input, but the module

remains undamaged.

View the M1410 XILINX board

The following module configuration is possible by setting jumpers 1 to 2:

Jumper 1

Watchdog on / off

for Port D0 and D1

If this jumper is set the ’Watchdog’ function is switched off.

This means if an error is detected the outputs set of Port D0

and D1 are not switched off.

Jumper 2

Latch on / off

standard configuration is jumper ’set’

input are latched in intervals of 6,8 ms

otherwise inputs are latched permanently

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sem comentários

Beckhoff M1410 Manual do Utilizador Página 8