Beckhoff CX1020 Manual do Utilizador descarregar pdf (Página 110)

Error handling and diagnostics

108 Embedded PC

9 pulses

0 Checksum error in Flash

program

Revert to the manufacturer’s setting

n (n>0) Bus Terminal n is not

consistent with the

configuration that existed

when the boot project was

created

Revert to the manufacturer's setting which

will clear the boot project.

14 pulses

n nth Bus Terminal has the

wrong format

Start the power supply again, and if the error

occurs again then exchange the Bus

Terminal.

15 pulses

n Number of Bus Terminals is

no longer correct

Start the power supply up again.

16 pulses

n Length of the K-Bus data is

no longer correct

Start the power supply up again.

Error code argument

The number of pulses indicates the position of the last Bus Terminal before the fault. Passive Bus Terminals, such as

a power feed terminal, are not included in the count.

In the case of some errors, rectification does not cause the power supply to leave the blink sequence. The power

supply can only be restarted by switching its supply voltage off and on again.

Note:

The supply voltage of the power supply unit, which is necessary to supply power to the CX1000 system, must not be

interrupted in the middle of operation. Switching off the supply voltage to the power supply unit refers here to the

power supply on the power contacts.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 122 123

Sem comentários

Beckhoff CX1020 Manual do Utilizador Página 110